CHP12G PLATE Beveling MACHINE

chp_12_plate_bevelling_machine_working.jpg (8906 bytes) Beveling machine CHP 12

This Beveling machine works on the basis of Beveling by low speed rotating milling tool. Beveling machine is pulling the material in and at the same time it pushes it inwardly for the cut. When Beveling steel plates or metal stripes, the Beveling machine is set on the edge of the beveled material on which it propels itself forward. The Beveling action is virtually without noise. When a need of X weld arises, the material is turned upside down and is then put into Beveling machine from the other side or it is possible to turn the Beveling machine "upside down" and put it on the edge of the metal. In latter case the Beveling starts on the other side. The size of the bevel can be easily changed, up to the full maximum potential of any given Beveling machine.

Beveling machine CHP 6 and12 have all basic angle of bevel of 30 degrees and can be changed with a set of rolling assembly – accessories that can be ordered as additional tools. The angles available are 45, 37.5, 35 and 22.5 degrees.

This Beveling machine can also bevel circular shapes and it is possible to use them for Beveling of pipes.

Cutting tool on this Beveling machine usually lasts 6000 feet on appropriate tensile strength of steel and it is possible to re-sharpen it.

CHP12 bevelling machine at work.jpg (14776 bytes) cutter_chp12.jpg.JPG (1210 bytes) cutter

Watch Video